Metal Heavy Lube Heavy Equipment

Metal Heavy Lube Heavy Equipment Formula is the most used in millions of engines with truly amazing results. Its advanced formulation provides all types of engines, an extraordinary protection against friction and wear in all seasons and climates. It improves the cold start and protects the engine against wear in crucial situations such as: starting, short trips, high temperatures, failures in the lubrication system, etc.

It avoids the most severe problems of cam shaft wear, as well as the wear in the piston ring-segment, the scratching of the pistons and the carbon created in the combustion chamber are reduced.

It significantly increases the performance of all parts subjected to friction, extends their life and allows a motor to work even longer if it loses the pressure of the oil or the oil itself.

Drastically reduces friction between parts, up to 95%, this will result in lower fuel and oil consumption, also the temperature of the engine, oil and water or coolant, will be benefited by avoiding excessive pressures on the engine and in the cooling circuit.

In engines equipped with turbo, it provides precise lubrication and is highly resistant to temperature.

Reduces gas emissions, protects and lengthens the life of the catalyst and particle filter Improves engine response and increases its power, improves compression and balances on all cylinders, significantly reduces friction and vibration noise.

It avoids the premature oxidation of the oil and keeps its properties stable even longer in engines equipped with EGR systems.

A single application of Metal Lube Heavy Heavy Equipment Formula is effective for 100,000 Km / 62,000 miles, does not drain or get lost with oil changes, it can be used with new or used oil.

By not generating any type of layer or increase in part tolerances, it can be put into completely new engines, without losing the warranty of your vehicle.

MOST FREQUENTLY USED USES:
For use in all types of engines: gasoline, diesel, gas, etc.

APPLICATION AND DOSAGE:
The content of the 946ml container is sufficient for engines with a capacity of up to 40 liters of oil. In lower capacities, add 30ml of Metal Lube per liter of oil. It is not necessary to remove oil. It can be used with new or used oil. Repeat the application every 100,000 km / 62,000 miles or 2,000 hours of work.

METAL LUBE, is not an oil additive, it is not lost with the oil change, because it treats the metal, not the oil. Compatible with mineral and synthetic oil. You can use it in engines equipped with catalytic converter or particle filter.

* METAL LUBE does not repair mechanical failures.

NOTE:
For 4-stroke motorcycle engines with oil-filled clutches, use the FORMULA MOTOS 4 TIMES. The characteristics and effectiveness of this formulation are the same as the Motors formula, but with the quality of not affecting clutch discs bathed in oil.